Intrinsic Magnetic Proximity Effect at the Atomically Sharp Interface of CoxFe3-xO4/Pt Grown by Molecular Beam Epitaxy.

CoxFe3-xO4(CFO)/Pt bilayers prepared by molecular beam epitaxy were investigated for the anomalous Hall effect and X-ray magnetic circular dichroism (XMCD). We found that the anomalous Hall effect originates from a magnetic proximity effect at the CFO/Pt interface. The XMCD signal in the Pt L-edge was obtained only for the sample deposited at 600 °C, indicating that the magnetic proximity effect is sensitive to the interface structure. Transmission electron microscopy images of the CFO/Pt interface and XMCD measurements of Co and Fe L-edges do not provide direct evidence for interfacial atomic diffusion or alloying. In summary, these results suggest that the magnetic proximity effect is robust for transport properties, such as the anomalous Hall effect, while the induced magnetic moment depends on slight differences in the interfacial structure, such as the presence or absence of interfacial oxygen ions.

Ultrahigh pressure-induced modification of morphology and performance of MOF-derived Cu@C electrocatalysts.

We report the pyrolysis of copper-containing metal-organic frameworks under high pressure and the effect of the applied pressure on the morphology and electrocatalytic performance toward the oxygen-related reactions of the products. The high-pressure and high-temperature (HPHT) syntheses were performed under 5, 2.5, 1, and 0.5 GPa, and the Cu@C products were obtained except for the 2.5 GPa experiment. Copper formed a shell-like nanostructure on the carbon matrices during the 0.5 GPa experiment, whereas copper formed sub-nanometer sized particles in the carbon matrices with the increasing pressure. It is considered that the transportation of copper atoms by outgassing during the pyrolysis affects the morphology. Electrochemical measurements revealed that all samples exhibited activity for the oxygen reduction reaction (ORR). The 0.5 GPa-treated product also exhibited the oxygen evolution reaction (OER). The overall ORR/OER performance of this product was excellent among Cu-based bifunctional materials even though it did not contain cocatalysts such as nitrogen-doped carbon or other metal elements. The Cu(iii) species in the nano-thick copper shell structure provided the active sites for the OER.

Molecular Dynamics Simulation of Poly(Ether Ether Ketone) (PEEK) Polymer to Analyze Intermolecular Ordering by Low Wavenumber Raman Spectroscopy and X-ray Diffraction.

Poly(ether ether ketone) (PEEK) is an important engineering plastic and evaluation of its local crystallinity in composites is critical for producing strong and reliable mechanical parts. Low wavenumber Raman spectroscopy and X-ray diffraction are promising techniques for the analysis of crystal ordering but a detailed understanding of the spectra has not been established. Here, we use molecular dynamics combined with a newly developed approximation to simulate local vibrational features to understand the effect of intermolecular ordering in the Raman spectra. We found that intermolecular ordering does affect the low wavenumber Raman spectra and the X-ray diffraction as observed in the experiment. Raman spectroscopy of intermolecular vibration modes is a promising technique to evaluate the local crystallinity of PEEK and other engineering plastics, and the present technique offers an estimation without requiring heavy computational resources.

Synthesis of Epitaxial MoS2/MoO2 Core-Shell Nanowires by Two-Step Chemical Vapor Deposition with Turbulent Flow and Their Physical Properties.

MoO2 nanowires (NWs), MoO2/MoS2 core-shell NWs, and MoS2 nanotubes (NTs) were synthesized by the turbulent flow chemical vapor deposition of MoO2 using MoO3, followed by sulfurization in the sulfur gas flow. The involvement of MoO x suboxide is suggested by density functional theory (DFT) calculations of the surface energies of MoO2. The thickness of the MoS2 layers can be controlled by precise tuning of sulfur vapor flow and temperatures. MoS2 had an armchair-type winding topology due to the epitaxial relation with the MoO2 NW surface. A single ∼ few-layer MoO2/MoS2 core-shell structure showed photoluminescence after the treatment with a superacid. The resistivities of an individual MoO2 NW and a MoS2 NT were measured, and they showed metallic and semiconducting resistivity-temperature relationships, respectively.

Growth of Pentacene Crystals by Naphthalene Flux Method.

We report the crystal growth of pentacene from a solution of naphthalene. The solubility of pentacene in naphthalene was evaluated by optical absorption at elevated temperature. The crystal growth was performed in an H-shaped sealed glass tube or metal vessels sealed with ultrahigh-vacuum compatible flanges placed in heated two-zone aluminum blocks. The obtained crystals had a single-crystal-like appearance and flat surface. They were made of aligned microtwins of the "bulk type" (interlayer spacing 14.5 Å) polymorph.

Stabilization of Interfacial Polarization and Induction of Polarization Hysteresis in Organic MISIM Devices.

Molecule-based ferroelectrics has attracted much attention because of its advantages, such as flexibility, light weight, and low environmental load. In the present work, we examined an organic metal|insulator|semiconductor|insulator|metal (MISIM) device structure to stabilize the interfacial polarization in the S layer and to induce polarization hysteresis even without bulk ferroelectrics. The MISIM devices with I = parylene C and S = TMB (=3,3',5,5'-tetramethylbenzidine)-TCNQ (=tetracyanoquinodimethane) exhibited hysteresis loops in the polarization-voltage (P-V) curves not only at room temperature but also over a wide temperature range down to 80 K. The presence of polarization hysteresis for MISIM devices was theoretically confirmed by an electrostatic model, which also explained the observed thickness dependence of the I layers on the P-V curves. Polarization hysteresis curves were also obtained in MISIM devices using typical organic semiconductors (ZnPc, C60, and TCNQ) as the S layer, demonstrating the versatility of the interfacial polarization mechanism.

Rate-determining process in MISIM photocells for optoelectronic conversion using photo-induced pure polarization current without carrier transfer across interfaces.

Recently, we proposed a [metal|insulator|semiconductor|insulator|metal] (MISIM) photocell, as a novel architecture for high-speed organic photodetectors. The electric polarization in the S layer, induced by modulated light illumination, propagates into the outside circuit as a polarization current through the I layers, without any carrier transfer across the interfaces. In the present work, we examined the MISIM photocells consisting of zinc-phthalocyanine(ZnPc)-C60 bilayers for the S layer and Parylene C for the two I layers, to understand the fundamental aspects of the MISIM photocells, such as current polarity and modulation-frequency dependence. It was found that, in such devices, the current polarity was primarily determined by the polarization in the S layer, which was induced by the donor-acceptor charge-transfer upon illumination. Furthermore, the ON and OFF current, which appeared in the periods of illumination-on and -off, respectively, exhibited significantly different dependence on the modulation frequency. This was well-explained by an imbalance between a quick polarization in the S layer during illumination and its slow relaxation in the dark.

Ferroelectricity and Piezoelectricity in Free-Standing Polycrystalline Films of Plastic Crystals.

Plastic crystals represent a unique compound class that is often encountered in molecules with globular structures. The highly symmetric cubic crystal structure of plastic crystals endows these materials with multiaxial ferroelectricity that allows a three-dimensional realignment of the polarization axes of the crystals, which cannot be achieved using conventional molecular ferroelectric crystals with low crystal symmetry. In this work, we focused our attention on malleability as another characteristic feature of plastic crystals. We have synthesized the new plastic/ferroelectric ionic crystals tetramethylammonium tetrachloroferrate(III) and tetramethylammonium bromotrichloroferrate(III), and discovered that free-standing translucent films can be easily prepared by pressing powdered samples of these compounds. The thus obtained polycrystalline films exhibit ferroelectric polarization switching and a relatively large piezoelectric response at room temperature. The ready availability of functional films demonstrates the practical utility of such plastic/ferroelectric crystals, and considering the vast variety of possible constituent cations and anions, a wide range of applications should be expected for these unique and attractive functional materials.

Transport Characteristics of the Organic Field-Effect Transistors Based on Charge Transfer Complex as Semiconductors.

The n-type organic field-effect transistors are fabricated with using four kinds of charge transfer (CT) complexes with PXX (peri-xanthenoxanthene) as a donor component. The CT complexes with four kinds of acceptors form mixed-stack type one-dimentional columns with different PXX-acceptor overlaps. Comparison of the field-effect properties reveals the correlation between the device performance and intermolecular interaction in the semiconducting CT complexes.